Specifications

Installation and Operation Manual Chapter 5 Configuring Typical Applications
RICi-622GE Ver. 1.0 Configuring a Traffic Aggregation Application 5-13
The necessary flow configuration is shown in the following table. A separate flow
must be configured for each remote RICi-155GE unit.
Table 5-5. Flow Configuration Summary, Aggregation Application
Remote Unit Flow ID Bridge Port CE-VLAN-ID Bridge Port SP-VLAN-ID
RICi-155GE (A) 3 LAG-1 1000–1500 VCG-1 200
RICi-155GE (B) 4 LAG-1 1501–2000 VCG-2 300
RICi-155GE (C) 5 LAG-1 2001–2500 VCG-3 400
RICi-155GE (D) 6 LAG-1 2501–3000 VCG-4 500
Configuring System Parameters
³ To configure the host parameters:
• Display the Host menu (Main> Configuration> System > Host), and configure
the host parameters as shown below.
RICi-622GE
Configuration>System>Management>Host
1. IP address ... (192.168.10.50)
2. IP mask ... (255.255.255.0)
3. Default Gateway ... (192.168.10.1)
4. Read community ... (public)
5. Write community ... (public)
6. Trap community ... (public)
7. Encapsulation >
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 5-22. Configuring Host IP Parameters for RICi-622GE,
Multipoint Application
Configuring Ethernet Link Aggregation
You must configure link aggregation for the Gigabit Ethernet ports.
To configure the Gigabit Ethernet link aggregation:
1. Navigate to the LAG menu (Configuration > Physical Layer > LAG).
The LAG menu appears, indicating the Link Aggregation status is disabled.