Specifications

Installation and Operation Manual Chapter 5 Configuring Typical Applications
RICi-622GE Ver. 1.0 Configuring a Point-to-Point Application 5-3
Configuring Bridge Ports
The bridge port configuration procedure is similar for the Gigabit Ethernet bridge
ports in both RICi-622GE units. You must configure the bridge ports as shown in
Table 5-1 .
³ To configure the Gigabit Ethernet ports:
1. From the Bridge Port menu (Configuration > Application > Bridge > Bridge
Port), select the first Gigabit Ethernet port of RICi-622GE (A).
2. From the Bridge Port Parameters menu, set flow classification mode to
flow-based.
3. From the Bridge Port Parameters menu, set flow key to CE-VLAN-ID.
4. From the Bridge Port Parameters menu, set CoS Profile to DefaultCosPBits1.
5. Perform steps
2 through 4 for the second Gigabit Ethernet port of
RICi-622GE (A), and for the first Gigabit Ethernet port of RICi-622GE (B).
RICi-622GE
Configuration>Application>Bridge>Bridge Port
Bridge Port > (ETH-1)
1. Usage > (User)
2. Accept frame type (All)
3. Flow Classification Mode (Flow-based)
4. Flow Key > (CE-VLAN ID)
5. CoS Profile > (DefaultCosPBits1)
6. Default VID [1-4094] ... (1)
7. Default 802.1p [0-7] ... (0)
8. Ingress MTU [64-9600] ... (2048)
9. L2CP Handling >
10. Egress Bandwidth profile >
11. Loop detection (Disable)
>
F - Forward ;
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 5-3. Configuring Bridge User Port
Configuring the Flows
In RICi-622GE (A), you must configure a flow for each Gigabit Ethernet port, with
CE VLAN and SP VLAN memberships as shown in
Table 5-3 . In RICi-622GE (B), you
must configure two flows for one Gigabit Ethernet port, with CE VLAN and
SP VLAN memberships as shown in
Table 5-4 .