Specifications

Chapter 5 Configuring Typical Applications Installation and Operation Manual
5-2 Configuring a Point-to-Point Application RICi-622GE Ver. 1.0
Table 5-2. Bridge Port Configuration Summary
Bridge Port Flow Classification Mode
Gigabit Ethernet 1, RICi-622GE (A) Flow-based
Gigabit Ethernet 2, RICi-622GE (A) Flow-based
Gigabit Ethernet 1, RICi-622GE (B) Flow-based
Table 5-3. Flow Configuration Summary, RICi-622GE (A)
Bridge Port Flow ID CE-VLAN-ID Bridge Port SP-VLAN-ID
Gigabit Ethernet 1 3 20 VCG 220
Gigabit Ethernet 2 4 30 VCG 230
Table 5-4. Flow Configuration Summary, RICi-622GE (B)
Bridge Port Flow ID CE-VLAN-ID Bridge Port SP-VLAN-ID
Gigabit Ethernet-1 3 20 VCG 220
Gigabit Ethernet-1 4 30 VCG 230
Configuring System Parameters
The configuration procedure for system parameters is similar for both RICi-622GE
units, except for defining different host IP addresses. Refer to
Chapter 3 for an
explanation of how to select management options and save the changes.
³ To configure the host parameters:
• Display the Host menu (Configuration> System >Management>
Host), and
configure the host parameters as shown in
Table 5-1 .
RICi-622GE
Configuration>System>Management>Host
1. IP address ... (192.168.10.10)
2. IP mask ... (255.255.255.0)
3. Default Gateway ... (192.168.10.1)
4. Read community ... (public)
5. Write community ... (public)
6. Trap community ... (public)
7. Encapsulation >
>
ESC-prev. menu; !-main menu; &-exit 1 M/2 C
Figure 5-2. Configuring Host Parameters for RICi-622GE (A),
Point-to-Point Application