Specifications

Chapter 4 Configuration Installation and Operation Manual
4-42 Configuring RICi-622GE for Operation RICi-622GE Ver. 1.0
Parameter Function Values
Color Mode Specifies if RICi-622GE takes into account
the color of the frames assigned by the port
mapping rules or if all frames are considered
to be “green”
Permanently set to Blind – All frames are
considered to be “green”
Coupling Flag Determines if the allowed “yellow” frame
rate is defined by the EIR or EIR+CIR value.
Available only when the color mode is set to
Aware.
Permanently set to Disable –The allowed
“yellow” frame rate is defined by the EIR
Defining the Ethernet Flows
RICi-622GE supports up to 16 Ethernet flows that are used to provide E-line
service delivery over Metro Ethernet networks. Each Ethernet flow connects a
network and a user port. For each Ethernet flow, you must define:
• Flow members, depending on the selected port flow key (CE-VLAN ID,
CE 802.1p, or SP-VLAN ID)
• Marking mode
• Ingress bandwidth profile
• Services or CoS.
Configuration parameters of existing flows cannot be changed. To change the
configuration of an existing flow, delete it and redefine it with the required
parameters.
You cannot use a management VLAN in a user data flow.
Adding an Ethernet Flow
³ To add an Ethernet flow:
1. From the Flow menu (Configuration > Application > Flows), type a to add a
flow.
2. Enter a new flow ID (1–16).
3. Select Flow Name and assign a name to the flow (alphanumeric string of up
to 20 characters).
4. Select Bridge Port List to display the Bridge Port List menu and configure the
bridge ports that serve the flow (see
Configuring the Flow Bridge Ports
section below).
Note