Specifications
Optimux-XLT1 Installation and Operation Manual Chapter 4 Supervisory Port Software Configuration
The Optimux-XLT1 Interface 4-17
23. Type 7 to set the speed.
The Change Interface Configuration screen changes and appears as follows:
LOCAL DEVICE
CHANGE INTERFACE CONFIGURATION
------------------------------
NOTE: To change the configuration of the interface, select it
in the next format:
- decimal number from 1 to 5 for modules,
(1 for module A, 2 for module B,..., 5 for E3 link)
0. Exit
1. Module module B
2. Back Pressure Disable
3. Half/Full duplex N/A
4. Auto-negotiation Enable
5. Multicast blocking Disable
6. Broadcast blocking Disable
7. Speed N/A
8. Reset
Choose 1–for 10Mbps, 2–for 100Mbps, ESC– for cancel
24. Type 1 to set the module speed to 10 Mbps or 2 to set the module speed to
100 Mbps.
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com