Specifications

Optimux-XLT1 Installation and Operation Manual Chapter 4 Supervisory Port Software Configuration

The Optimux-XLT1 Interface 4-13

15. Type 3 to set the port operation mode.

The Change Interface Configuration screen changes and appears as follows:

LOCAL DEVICE

CHANGE INTERFACE CONFIGURATION

------------------------------

NOTE: To change the configuration of the interface, select it

in the next format:

- decimal number from 1 to 5 for modules,

(1 for module A, 2 for module B,..., 5 for E3 link)

0. Exit

1. Module module B

2. Back Pressure Disable

3. Half/Full duplex N/A

4. Auto-negotiation Enable

5. Multicast blocking Disable

6. Broadcast blocking Disable

7. Speed N/A

8. Reset

Choose 1–for ‘Full duplex’ 2–for ‘Half duplex’, ESC to cancel

16. Type 1 to set operation to full duplex or 2 to set operation to half duplex.

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610