Specifications

Installation and Operation Manual Chapter 3 Configuration
MPW-1 MP-4100 Ver. 2.0 Viewing Ethernet Flows Associated with Pseudowires 3-33
3.6 Viewing Ethernet Flows Associated with
Pseudowires
After performing the pseudowire configuration activities listed above, you can
view the Ethernet traffic flows that are used by pseudowires.
For the supervision terminal, use Configuration > Applications >
Ethernet Services > Flows (for instructions, refer to the
Megaplex-4100
Installation and Operation Manual
).
The Ethernet flow of each pseudowire is an E-line flow, and therefore it has
exactly two bridge ports:
• One bridge port is the router interface used by corresponding pseudowire
• The other bridge port is the selected exit port:
 For I/O modules with Ethernet ports (for example, M8E1, M8T1, M8SL,
OP-108C, OP-106C, MPW-1): a specific ETH port (ETH-1, ETH-2 or ETH-3).
 For CL.1/GbE modules: the GbE port, GbE-1 or GbE-2.
 For CL.1/155GbE modules: a GbE port, GbE-1 or GbE-2, or a virtually
concatenated group, VCG1 to VCG8.