Specifications

Installation and Operation Manual Chapter 3 Configuration
MPW-1 MP-4100 Ver. 2.0 Configuring Pseudowire Services 3-29
Parameter Function Values
Data OOS Selects the code transmitted by the
port during out-of-service periods on
the timeslots defined as data
timeslots (see the
Configuring
Internal DS1 Port Timeslot Utilization
section).
The selected code is also sent during
out-of-service periods instead of the
external data stream when the
UNFRAMED mode is used
The available selections are 00 to FF (hexa).
Default: 00
OOS Signaling Determines the state of the signaling
bits sent to the internal DS1 port
connected to the selected
pseudowire during out-of-service
periods.
This parameter is displayed only
when the attached internal DS1 port
is configured with Signaling = YES
FORCED IDLE – The signaling bits are forced to
the idle state (05 hexa) during out-of-service
periods.
FORCED BUSY – The signaling bits are forced to
the busy state (0F hexa) during out-of-service
periods.
Default: FORCED IDLE
Attachment
Circuit
Opens the pseudowire attachment
circuit parameters screen
See Table 3-11
Table 3-11. Pseudowire Attachment Circuit Parameters
Parameter Function Values
Slot Selects the I/O slot number on which
the pseudowire will be terminated.
You can select only I/O slots in which
MPW-1 modules are programmed
IO-1 to IO-10.
Default: IO-1
Int DS1 Number Selects the internal DS1 port of the
selected MPW-1 to which the
pseudowire is connected
The allowed range is 1 to 8.
Default: 1
Time Slots Displays the timeslot assignment
submenu for this pseudowire.
This item is displayed only when the
internal DS1 port uses the DS0
cross-connect mode
See below
Selecting Internal DS1 Timeslots Connected to a Pseudowire
The internal DS1 ports provide a connection point between TDM traffic arriving
from other modules and the pseudowires supported by MPW-1 (see the
Configuring Internal DS1 Port Timeslot Utilization section starting on page 3-11 ).
Each pseudowire can be connected to only one internal DS1 port.
When the internal DS1 port to which the pseudowire uses the DS0 cross-connect
mode, you must specify the timeslots to be served by the pseudowire.