Specifications

Chapter 3 Configuration Installation and Operation Manual
3-24 Configuring Pseudowire Services MPW-1 MP-4100 Ver. 2.0
 Now, you cannot assign the next label (Out PW Label of 101 in this
example) to a pseudowire using payload Version V2, because the resulting
source UDP port is also 101
So, you must skip (never use) the pseudowire label next to the label assigned
to pseudowire payload Version V1, if the next pseudowire uses payload
Version V2.
• For CESoPSN and SAToPSN pseudowires using packet payload Version V2:
UDP Source Port = Pseudowire Number + C000
This means that all the UDP ports numbers are higher than C000 hexa (49152
decimal).
³ To select the pseudowire PSN parameters:
1. Navigate to the Configuration > Applications > Multi-Service over PSN > PW
screen of the desired pseudowire.
2. Select PSN Parameters.
You will see the PSN Parameters screen of the desired pseudowire. The
pseudowire index, its I/O slot and logistic name, and the pseudowire type
are automatically displayed at the top of the screen.
3. Obtain the prescribed parameters, and then use
Table 3-9 for parameter
descriptions and configuration guidelines.