Specifications

Quick Start Guide Installation and Operation Manual
2 MPW-1 MP-4100 Ver. 2.0
Configuring Physical Layer Parameters
Configuring Internal DS1 Ports Physical Layer Parameters
For the supervision terminal, use the Configuration > Physical Layer > I/O screen.
Parameter Values Parameter Values
Port Number 1 to 8 Wait to Restore 0 to 999 seconds
Administrative
Status
DOWN
UP
Cross Connect DS0 (framed modes only)
DS1
Name Up to 32 alphanumeric
characters
Destination Slot
(DS1 cross-connect
mode only)
CL
IO-1 to IO-10
Redundancy NONE
DUAL CABLE P.TX
Destination Port
(DS1 cross-connect
mode only)
E1 or T1 external or internal
ports: 1 to 8
DS1 ports: 1 to 8
STM-1 PDH ports: 1 to 63 for
OC-3 PDH ports: 1 to 84
Primary
(when Redundancy
is DUAL CABLE P.TX)
YES
NO
Framing FRAMED
UNFRAMED
Redundant Slot
(when Redundancy
is DUAL CABLE P.TX)
CL
I/O-1 to I/O-10
Signaling NO
YES
Redundant Port
(when Redundancy
is DUAL CABLE P.TX)
E1 or T1 external or internal
ports: 1 to 8
DS1 ports: 1 to 8
STM-1 PDH ports: 1 to 63 for
OC-3 PDH ports: 1 to 84
Configuring Internal DS1 Port Timeslot Utilization
For framed internal DS1 ports using the DS0 cross-connect mode, configure
timeslot assignment (including timeslots using split assignment).
For the supervision terminal, use the last item, Time Slot Assignment, on the
Configuration > Physical Layer > I/O screen of the desired MPW-1 internal DS1
port, or use the Configuration > System > TS Assignment screen in accordance
with the information appearing in the
Megaplex-4100 Installation and Operation
Manual
.