Specifications

Installation and Operation Manual Chapter 3 Configuration
MPW-1 MP-4100 Ver. 2.0 Default Settings 3-5
Parameter Description Factory Default Value
Peer Number Pseudowire destination index number 1
OAM Mode Pseudowire OAM support Proprietary
Out PW Label UDP/IP: UDP source port number.
MPLS/ETH: outer (tunnel) MPLS label
1
16
In PW Label UDP/IP: UDP destination port number.
MPLS/ETH: inbound MPLS label
1
16
Pseudowire PSN Parameters
ToS Layer 3 priority assigned to the traffic generated by this
pseudowire (relevant only for UDP/IP PSN)
0
Ingress Tunnel Tagging Use of an interworking MPLS label for the receive
(inbound) direction of the pseudowire (relevant only for
MPLS/ETH PSN)
Disable
Ingress Tunnel Label Inbound MPLS label used for the pseudowire (relevant only
for MPLS/ETH PSN)
16
Egress Tunnel Tagging Use of an interworking MPLS label for the transmit
(outbound) direction of the pseudowire (relevant only for
MPLS/ETH PSN)
Disable
Egress Tunnel Label Outbound MPLS label used for the pseudowire (relevant
only for MPLS/ETH PSN)
16
EXP Bits Value of the outbound EXP bits in the pseudowire MPLS
pseudowire header, used to indicate the requested Quality
of Service (relevant only for MPLS/ETH PSN)
0
VLAN Priority Layer 2 priority assigned to the pseudowire traffic when
VLAN Tagging is enabled
0
Payload Format Packet payload format V2
Pseudowire Service Parameters
TDM Bytes in Frame Number of TDM payload bytes (TDM frames for CESoPSN)
inserted in each packet (packet size)
TDMoIP: 1 × 48
CESoPSN: 4
Payload Size TDM payload size 4 to 1440
Jitter Buffer Value of the jitter buffer to be used on this pseudowire 2500
Far End Type Framing used by the equipment at the destination
endpoint
E1
Delay Sensitivity Optimum mode of the clock recovery mechanism Data
Voice OOS Code transmitted during out-of-service periods on
timeslots defined as voice timeslots
00
Data OOS Code transmitted by the port during out-of-service periods
on timeslots defined as data timeslots
00