Specifications

Chapter 3 Configuration Installation and Operation Manual
3-4 Default Settings MPW-1 MP-4100 Ver. 2.0
Parameter Description Factory Default Value
Ethernet Port – Physical Layer Configuration Parameters
Port Number Ethernet port number 1
Administrative Status Ethernet port administrative status Down
Name Ethernet port logical name Empty string
Auto Negotiation Ethernet port autonegotiation mode Enable
Max. Capability
Advertised
Highest traffic handling capability advertised when
autonegotiation is enabled
100Mbps Full Duplex
Speed & Duplex Ethernet port data rate and operating mode when
autonegotiation is disabled
100Mbps Full Duplex
Router Parameters
Default Gateway Default gateway IP address 0.0.0.0
ARP Aging Time (sec) Aging time for ARP entries 1200
Router Interface Parameters
Number Router interface index number 1
Name Router interface logistic name RI#1
IP Address IP interface address 0.0.0.0
IP Mask IP interface subnet mask 0.0.0.0
Slot I/O slot of router interface CL-A
Port Router interface exit port GbE-1
VLAN Tagging VLAN tagging Disable
VLAN ID VLAN ID 1
Static Routes Parameters
Number Static route index number 1
IP Address Static route IP address 0.0.0.0
IP Mask Static route IP subnet mask 0.0.0.0
Next Hop Next hop IP address 0.0.0.0
Peer Parameters
Peer Number Peer index number 1
Name Peer logistic name Peer-1
Peer IP Address Peer IP address 0.0.0.0
Peer Next Hop Address Peer next port IP address 0.0.0.0
General Pseudowire Parameters
PW Type Pseudowire encapsulation protocol TDMoIP CE
PSN Type Pseudowire PSN header UDP/IP