Specifications

Chapter 1 Introduction Installation and Operation Manual
1-28 Technical Specifications MPW-1 MP-4100 Ver. 2.0
Payload Routing
Packet Routing
• Static routing (up to 100 static routes per
Megaplex-4100)
• Up to 6 router interfaces per MPW-1, and up to 100
router interfaces per Megaplex-4100 (each router
interface has its own source IP address)
• Up to 100 pseudowire destinations (peers) per
Megaplex-4100
Exit Ports
• User-defined internal routing (any packet processor
to any external Fast Ethernet port), and connection
parameters (each pseudowire to any destination)
• For Megaplex-4100 with GbE ports: in accordance
with user-defined flows, to any bridge port in
Megaplex-4100
Ethernet
Interfaces
Number of Ports Three 10/100 Mbps ports (either fiber-optic or copper, in
accordance with order)
Data Rate and
Mode
10 or 100 Mbps, half- or full-duplex, selected by
auto-negotiation or configured by the user
Maximum Frame
Size
1600 bytes
Fiber Optic Ports Hot-swappable SFPs
Note: For detailed specifications of the SFP transceivers,
see Table
1-1 and RAD SFP Transceivers data sheet. RJ-45
copper interfaces also available as SFPs (model SFP-9F)
Copper Ports
Type 10/100Base-TX
Connector Shielded RJ-45
Note: RJ-45 copper interfaces are also available for
MPW-1 with SFP sockets (RAD SFP model SFP-9F)
Indicators (per
Ethernet port)
• ACT (yellow): flashes in accordance with the transmit
and/or receive activity on the corresponding port
• LINK (green): lights when the link integrity signal is
detected by the corresponding port
Diagnostics
User-Controlled
Port Loopbacks
• Local loopback per selected timeslots on each internal
DS1 port
• Remote loopback per selected timeslots on each
internal DS1 port
Configuration
Programmable via Megaplex-4100 management system