Specifications

Appendix B Upgrading Software Installation and Operation Manual
B-2 Downloading and Installing Software MiRICi-E3T3 Ver. 2.2
7. Select the Settings tab and under Emulation, choose VT100, and then click
OK.
The COM port configuration is complete, and the HyperTerminal
connection is ready for use.
8. Close HyperTerminal.
B.2 Downloading and Installing Software
Once HyperTerminal is ready to communicate with MiRICi-E3T3 via SFP-CA and
you have verified the location of the upgrade image file, you can download the
software and upgrade MiRICi-E3T3.
³ To download and upgrade the MiRICi-E3T3 software:
1. Verify that the upgrade image file provided to you is accessible from your PC.
2. Set MiRICi-E3T3’s DIP switches to SW Download (SW DNLD) mode and then
plug the MiRICi-E3T3 device into the SFP-CA configuration module’s SFP port.
3. Open HyperTerminal and load the HyperTerminal connection you established.
The first screen appears indicating that the system is ready for
downloading.
============================================================
= (C) RAD Data Communication =
= =
= Software Download ( version X.XX) =
= =
= =
============================================================
1 – Download an application by YMODEM
• MiRICi-E3T3 is automatically upgraded once the new image file has been
downloaded.
• If you plug MiRICi-E3T3 in before connecting the SFP-CA unit to the PC, only
the Download message appears. The upgrade is correctly performed.
4. Press <1>.
A warning appears indicating that the disk will be modified.
5. Press <Y>.
Sectors are erased and the Send File screen appears, prompting you to
specify the name and the location of the upgrade image file.
6. In the toolbar, click Send File.
The Send File screen appears.
7. In the Send File window, under Protocol, choose Ymodem from the list.
Note