Specifications

MiRICi-E3T3 Ver. 2.2 Configuring HyperTerminal B-1
Appendix B
Upgrading Software
This section explains how to download and activate a new software version of
MiRICi-E3T3 by using the HyperTerminal application and the SFP-CA adaptor.
B.1 Configuring HyperTerminal
Upgrading MiRICi-E3T3 requires a PC with Windows XP SP2 installed, and equipped
with at least one available USB port, and the SFP-CA adaptor. The HyperTerminal
application is part of the Windows XP operating system. You must configure
HyperTerminal parameters before performing the software upgrade.
Before you can use SFP-CA with MiRICi-E3T3, you must install the SFP-CA driver
and configure the PC network parameters. Refer to
Chapter 3 for instructions.
³ To establish a HyperTerminal connection:
1. Connect the SFP-CA configuration module to a PC’s USB port as explained on
the previous page, using the SFP-CA configuration module’s USB connector.
New hardware is detected.
2. Before you insert MiRICi-E3T3 into the SFP-CA configuration module, open the
HyperTerminal application.
The Connection Description dialog box for a new connection appears.
3. Specify a name for the HyperTerminal connection, and click OK.
The Connect To dialog box appears.
4. Choose a virtual COM port, for example COM8 and click OK.
COM Properties appear.
5. Specify the settings as listed below and then click OK.
 Bits Per Content: 115200
 Data Bits: 8
 Parity: None
 Stop Bits: 1
 Flow Control: None.
6. Click Properties.
The Connection Properties screen appears.
Note