Specifications

Chapter 5 Configuring Typical Applications Installation and Operation Manual
5-4 Configuring MiRICi-E3T3 MiRICi-E3T3 Ver. 2.2
³ To configure the T3 port:
1. Navigate to the T3 menu (Configuration > Physical Ports > T3).
MiRICi-E3T3
Configuration > Physical Ports > T3
Tx Clock Source Internal Clock
Protocol GFP-F
(----VCAT Overhead Disable
(----Payload FCS(32 Bit) Disable
(----Scrambler Enable
(----GFP Keep Alive Disable
Line Code B3ZS
Line Type T3 C-bit
FEAC Code Receive Enable
Line Length Up to 225ft
Figure 5-5. T3 Menu
2. From the T3 menu, select the desired parameters as follows:
 Tx Clock Source. Select Internal Clock.
 Protocol. Choose a protocol according to the following MiRICi-E3T3
definitions:
 T3 Framed mode – GFP, HDLC or cHDLC (High Level Data Link
Control).
 T3 Unframed mode - HDLC or cHDLC (High Level Data Link Control)
 VCAT Overhead. Disable this parameter
 Payload FCS (32 Bit). Disable this parameter.
 Scrambler. If supported on both ends, enable Scrambling to truncate the
content of emails or voice messages until they arrive at its destination.
 GFP Keep Alive. Disable this parameter
 Line Code. Select B3ZS.
 Line Type. Select T3 C-bit.
 FEAC Code Receiver. Enabling this parameter ensures that FEAC bit codes
for “Loop up” and “Loop down” commands are processed.
3. Click Save.