Specifications

Installation and Operation Manual Chapter 5 Configuring Typical Applications
MiRICi-E3T3 Ver. 2.2 Configuring MiRICi-E3T3 5-3
Configuring the Ethernet Port
If the transmitting device transmits faster than the receiving device can receive,
you have to enable flow control, allowing MiRICi-E3T3 to send a pause frame
when necessary.
³ To enable Flow Control:
• In the Flow Control field of the Ethernet menu (Configuration > Physical Ports
> Ethernet), select Enable.
MiRICi-E3T3
Configuration > Physical Ports > Ethernet
Rate 1000 Mbps
Flow Control Enable
Figure 5-3. Ethernet Menu
Configuring the E3/T3 Port
You have to configure the T3 interface as follows.
³ To choose the interface type T3:
1. Navigate to the Physical Ports menu (Configuration > Physical Ports).
The Physical Ports menu appears.
MiRICi-E3T3
Configuration > Physical Ports
Ethernet
E3
Interface Type T3
Figure 5-4. Physical Ports Menu – Unit Currently in E3 Mode
2. Under Interface Type, select T3.
3. Click Save.
The unit is set to the selected interface type and the system reverts to
the Main menu.