Specifications

Chapter 5 Configuring Typical Applications Installation and Operation Manual
5-2 Configuring MiRICi-E3T3 MiRICi-E3T3 Ver. 2.2
5.1 Configuring MiRICi-E3T3
MiRICi-E3T3, connected to host devices such as routers or switches, forwards
Fast Ethernet or Gigabit Ethernet LAN packets to TDM-based WAN at full duplex
wire speed over E3 or T3 lines. Every MiRICi-E3T3 unit must be configured
separately.
Configuring the Host IP Parameters
The IP address serves as a destination for the management traffic. The default IP
address is 192.168.205.1. You have to assign a new IP address that is suitable
for your application.
³ To configure the host IP parameters:
1. In the IP address field of the Host IP menu (Configuration > System >
Management), assign new IP addresses 10.10.10.1, 10.10.10.2, etc. to each
MiRICi-E3T3 unit.
2. Assign the new IP mask 255.255.255.0 to all MiRICi-E3T3 units. All
MiRICi-E3T3 units and the management station must belong to the same
subnet.
3. Leave the remaining parameters unchanged.
MiRICi-E3T3
Configuration > System > Management > E3 > Host IP
IP Address 10.10.10.1
IP Mask 255.255.255.0
Default Gateway 0.0.0.0
Host Tagging Untagged
Figure 5-2. Host IP Menu (First MiRICi-E3T3 Unit)
Controlling Management Access
You can enable or disable Web access to MiRICi-E3T3 via WAN or LAN.
³ To enable or disable Web access to MiRICi-E3T3:
1. Navigate to the Management Access menu (Configuration > System >
Management > Management Access).
The Management Access menu appears.
2. Enable Web Access via both the LAN and the WAN interfaces.
3. Click Save.