Specifications

MiRICi-E3T3 Ver. 2.2 Additional Tasks 4-19
Table 4-3. Status Indicators
Parameter Description
LOS Loss of Signal encountered (ON), resolved (OFF)
LOF Loss of Frame (ON), resolved (OFF)
RDI Remote Alarm Indication (ON), resolved (OFF)
AIS Alarm Indication Signal (ON), resolved (OFF)
OOF Out of Frame (ON), resolved (OFF)
RL OL LIU Out of Lock (ON)
TX Disable Tx connection disabled (ON), enabled (OFF)
Wan Loop detected
Loop detected (ON), Loop not detected or loop
detection not activated (OFF)
You can select Statistics to display the logged statistical counters for the E3/T3
physical layer (Refer to Troubleshooting and Diagnostics).
Restoring Defaults
You can restore the MiRICi-E3T3 default settings.
³ To restore the MiRICi-E3T3 default settings:
1. From the System menu (Configuration > System), select Set Factory Defaults.
You are asked to confirm your request.
2. Click Yes to confirm your request.
MiRICi-E3T3 is reset and all settings are reset to the factory default.
Resetting MiRICi-E3T3
You can perform an overall reset of MiRICi-E3T3.
³ To reset MiRICi-E3T3:
1. In the System menu (Configuration > System), select Reset Device.
You are asked to confirm your request.
2. Click Yes to confirm your request.
MiRICi-E3T3 is reset and all parameters configured before saving them
last are preserved.