Specifications

Installation and Operation Manual Chapter 4 Configuration
MiRICi-E3T3 Ver. 2.2 Configuring for Operation 4-11
Configuring the Ethernet Port
This section instructs you on configuring the Ethernet port.
³ To configure the Ethernet port:
1. Navigate to the Ethernet menu (Configuration > Physical Ports > Ethernet).
The Ethernet menu appears.
MiRICi-E3T3
Configuration > Physical Ports > Ethernet
Rate 1000 Mbps (read-only)
Flow Control Disable
Figure 4-11. Ethernet Menu
2. Under Flow Control, choose Enable if the receiving device is sending a Pause
frame. This is necessary when the transmitting device transmits faster than
the receiving device can receive.
3. Click Save.
Possible rates are 100 or 1000 Mbps, depending on whether you are using a Fast
Ethernet (FE) or a Gigabit Ethernet (GbE) interface.
Configuring the E3 Port
This section instructs you on configuring the E3 interface.
³ To configure the E3 port:
1. Navigate to the E3 menu (Configuration > Physical Ports > E3).
The E3 menu appears.
MiRICi-E3T3
Configuration > Physical Ports > E3
Tx Clock Source LBT
Protocol HDLC
Line Code HDB3
Line Type E3 Unframed
Idle Code 7E
Figure 4-12. E3 Menu
Note