Specifications

Chapter 4 Configuration Installation and Operation Manual
4-10 Configuring for Operation MiRICi-E3T3 Ver. 2.2
Configuring MiRICi-E3T3 at the Physical Level
MiRICi-E3T3 allows you to configure for transmission over E3 or T3. You can
configure the Ethernet, E3, and T3 ports on the physical level.
Specifying the Interface Type
MiRICi-E3T3 can operate in both E3 and T3 environments without the need for
two different units.
³ To specify the interface type:
1. Navigate to the Physical Ports menu (Configuration > Physical Ports).
The Physical Ports menu appears.
MiRICi-E3T3
Configuration > Physical Ports
Ethernet
T3
Interface Type T3
Figure 4-10. Interface Type Menu – Unit Currently in T3 Mode
2. Under Interface Type, select the desired interface type, T3 or E3 respectively.
3. Click Save.
The selected interface type appears and you are able to access the
associated parameters. The system reverts to the Main menu.