Specifications

Installation and Operation Manual Chapter 4 Configuration
MiRICi-E3T3 Ver. 2.2 Configuring for Operation 4-9
• Remote defect indication (RDI)
• Alarm indication signal (AIS)
³ To configure the LOS behavior:
1. In the System menu (Configuration > System), click LOS Behavior.
The LOS Behavior menu appears, allowing you to enable or disable the
LOS behavior, depending on its cause.
MiRICi-E3T3
Configuration > System > LOS Behavior
LOS caused by:
LOS Disable
RLOL Disable
RDI Disable
AIS Disable
Figure 4-9. LOS Behavior Screen
2. Specify MiRICi-E3T3’s LOS behavior.
 LOS:
 Enable (LOS on the TDM link is propagated to the Ethernet interface)
 Disable (LOS on the TDM link is not propagated to the Ethernet
interface)
 RLOL:
 Enable (RLOL on the TDM link is propagated to the Ethernet interface)
 Disable (RLOL on the TDM link is not propagated to the Ethernet
interface)
 RDI:
 Enable (RDI on the TDM link is propagated to the Ethernet interface)
 Disable (RDI on the TDM link is not propagated to the Ethernet
interface)
 AIS:
 Enable (AIS on the TDM link is propagated to the Ethernet interface)
 Disable (AIS on the TDM link is not propagated to the Ethernet
interface)