Specifications

Chapter 4 Configuration Installation and Operation Manual
4-8 Configuring for Operation MiRICi-E3T3 Ver. 2.2
MiRICi-E3T3
Configuration > System > Fault Propagation
Fault Propagation caused by:
LOS Disable
FEAC Disable
LOF Disable
RLOL Disable
RDI Disable
AIS Disable
Fault Propagation WTR (sec) [0..3600] 0
Figure 4-7. Fault Propagation Menu
Configuring Tx Disable Mode
MiRICi-E3T3 lets you configure how the system responds to disabling the Tx
connection.
³ To configure the Tx Disable Mode
1. In the System menu (Configuration > System), click Tx Disable Mode.
The Tx Disable Mode screen appears.
MiRICi-E3T3
Configuration > System > Tx Disable Mode
Tx Disable Behavior Not Available
Figure 4-8. Tx Disable Mode Screen
2. To specify how the system is to respond when the Tx link fails:
 Not Available. The Tx link failure has no impact on MiRICi-E3T3 and no
action is taken.
 Tri-State. The E3/T3 framer is shut down.
 AIS. The Alarm Indication signal is activated.
Configuring LOS Behavior
MiRICi-E3T3 allows you to define whether to send the LOS indication to the
Ethernet interface when one of the following conditions is detected on the TDM
link:
• Loss of signal (LOS)
• Receive loss of lock (RLOL)