Specifications

Installation and Operation Manual Chapter 4 Configuration
MiRICi-E3T3 Ver. 2.2 Configuring for Operation 4-7
Alternatively, you can disable propagation of any of the supported conditions to
the Ethernet port.
You can also specify the wait-to-restore (WTR) time. WTR refers to the time
period that MiRICi-E3T3 waits before reconnecting an interface once the failed
interface has been restored.
³ To configure the fault propagation:
1. Navigate to the System menu (Configuration > System).
The System menu appears.
2. Enable or disable Fault Propagation respectively.
3. When enabled, select Fault Propagation to display the relevant menu and
configure the following parameters:
 LOS:
 Enable (LOS on the TDM link is propagated to the Ethernet interface)
 Disable (LOS on the TDM link is not propagated to the Ethernet
interface)
 FEAC:
 Enable (FEAC on the TDM link is propagated to the Ethernet interface)
 Disable (FEAC on the TDM link is not propagated to the Ethernet
interface)
 LOF:
 Enable (LOF on the TDM link is propagated to the Ethernet interface)
 Disable (LOF on the TDM link is not propagated to the Ethernet
interface)
 RLOL:
 Enable (RLOL on the TDM link is propagated to the Ethernet interface)
 Disable (RLOL on the TDM link is not propagated to the Ethernet
interface)
 RDI:
 Enable (RDI on the TDM link is propagated to the Ethernet interface)
 Disable (RDI on the TDM link is not propagated to the Ethernet
interface)
 AIS:
 Enable (AIS on the TDM link is propagated to the Ethernet interface)
 Disable (AIS on the TDM link is not propagated to the Ethernet
interface)
 Fault Propagation WTR (Wait-to-restore in seconds): 0-3600; 0 disables
the WTR.