Specifications

Chapter 4 Configuration Installation and Operation Manual
4-6 Configuring for Operation MiRICi-E3T3 Ver. 2.2
3. To disable I
2
C Cycle Stretching, select Without Stretching.
4. Click Save.
4.2 Configuring for Operation
The recommended configuration procedure for MiRICi-E3T3 includes the
following:
• Configuring system-level parameters
• Configuring Ethernet and E3/T3 interfaces at the physical level.
Configuring the System-Level Parameters
The system-level parameters of MiRICi-E3T3 include the following:
• Fault propagation
• LOS behavior
• Tx disable mode.
These parameters are configured via the System menu.
Configuring Fault Propagation
Fault propagation mechanism propagates the E3/T3 LOS signal to the
10/100BaseFx port. When the fault propagation is enabled, the Ethernet port is
disconnected if one of the following events is detected on the TDM interface:
• Loss of signal (LOS)
• Loss of frame (LOF)
• Far-end alarm and control (FEAC)
• Receive loss of lock (RLOL)
• Remote defect indication (RDI)
• Alarm indication SIGNAL (AIS)