Specifications

Chapter 4 Configuration Installation and Operation Manual
4-2 Configuring for Management MiRICi-E3T3 Ver. 2.2
2. From the Host IP menu (Configuration > System > Management > Host IP), do
the following:
 In the IP Address field, enter the host IP address
 In the IP Mask field, enter the host IP mask.
 In the Default Gateway field, set the default gateway IP address.
 Set Host tagging to be Tagged or Untagged to consider or ignore the
VLAN tagging of the management traffic coming from the management
station.
 If host tagging is enabled, two additional parameters appear:
 Host VLAN ID (ID of the host VLAN): 1–4094
 Host VLAN Priority (Priority of the host VLAN): 0–7
Before setting Host Tagging to Tagged, make sure that your PC is connected to
the VLAN or that another PC connected to the VLAN is available to continue
setting parameters.
Entering Device Information
The MiRICi-E3T3 management software allows you to assign a name to the unit,
add its description, specify its location to distinguish it from the other devices
installed in your system, and assign a contact person.
³ To enter device information:
1. Navigate to the Device Info menu
(Configuration > System > Management > Device Info).
The Device Info menu appears.
MiRICi-E3T3
Configuration > System > Management > Device Info
Description T3 Intelligent Converter
Device Name MiRICi-E3T3
Location
Contact Person
Figure 4-2. Device Info Menu
2. Select Device Name and enter a desired name for the MiRICi-E3T3 unit. The
default reflects the unit and the physical port type that you specified last, for
example MiRICi-E3.
3. In the Device Location field, enter the desired name for the current
MiRICi-E3T3 location.
4. In the Contact Person field, enter the name of a contact person.
Note