Specifications

MiRICi-E3T3 Ver. 2.2 Configuration and Management Alternatives 3-4
³ To configure the PC network parameters for the SFP-CA connection to
MiRICi-E3T3:
1. Connect the SFP-CA configuration unit to a USB port on your PC. For
additional information, refer to
Chapter 2 .
The New Hardware is Detected notice appears.
2. Right-click My Network Places.
A new local area network connection appears in the list of network
connections.
3. Right-click the new local area connection and rename it SFP-CA.
4. Right-click Properties, click Configure, and select the Advanced tab
The Network Connection Properties dialog box appears.
5. Choose Select Media and under Value, choose Home LAN, and then click OK.
The dialog box closes and your settings are applied.
6. Right-click the SFP-CA connection and click Properties.
The Local Area Connection Properties dialog box appears.
7. Select Internet Protocol (TCP/IP) and click Properties.
The Internet Protocol (TCP/IP) dialog box appears.
8. To enable entering TCP/IP settings, select Use the following IP Address.
The IP Address, the Subnet Mask and the Default Gateway field become
available.
9. Enter the following TCP/IP settings and then click OK:
 IP Address: 192.168.205.20
 Subnet Mask: 255.255.255.0
 Default Gateway: 192.168.205.1
10. Close My Network Places.
The PC communication link with MiRICi-E3T3 is ready.
³ To assign a new IP address to MiRICi-E3T3:
1. Set MiRICi-E3T3 to Configuration mode, using its DIP switches (see
Chapter 2 ).
Setting a different working mode via the DIP switches requires disconnecting
MiRICi-E3T3 from any device (SFP-CA or host).
2. Plug MiRICi-E3T3 into the SFP socket of the SFP-CA module.
3. Connect SFP-CA to your PC via USB 2.0 port.
The Ready LED on SFP-CA turns on.
Note