Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-4 Connecting MiRICi-E3T3 to E3/T3 Equipment MiRICi-E3T3 Ver. 2.2
The Safely Remove Hardware screen appears listing all USB devices
currently connected to your PC.
3. Select ADM8511 USB To Fast Ethernet Adapter and click Stop.
A message appears confirming that you can safely remove the device.
If you disconnect MiRICi-E3T3 and/or the SFP CA module before releasing it, your
PC may stop responding.
³ To disconnect MiRICi-E3T3 from the PC:
1. Push the release button at the front of MiRICi-E3T3, and then eject MiRICi-
E3T3 from SFP-CA.
2. Disconnect SFP-CA from the PC and from the power.
2.8 Inserting MiRICi-E3T3 into a Host Unit
This chapter explains how to connect (eject) MiRICi-E3T3 to (from) a host unit.
You do not have to switch off the host unit when inserting or extracting
MiRICi-E3T3.
³ To insert MiRICi-E3T3:
1. Set the DIP switches to the desired operation mode as specified in
Table 2-1 .
2. Insert MiRICi-E3T3 into a free SFP (MSA-compatible) socket of the host
equipment.
3. Press MiRICi-E3T3 firmly into the MSA SFP port connector.
MiRICi-E3T3 is ready to operate.
³ To eject MiRICi-E3T3:
1. Disconnect cables attached to MiRICi-E3T3.
2. Push the release button at the front of MiRICi-E3T3. This extracts the device
from the edge connector.
3. Remove MiRICi-E3T3 from the socket.
2.9 Connecting MiRICi-E3T3 to E3/T3 Equipment
MiRICi-E3T3 can be connected to E3/T3 equipment.
³ To connect to E3/T3 equipment:
• Use the miniature BNC cables (included in the MiRICi-E3T3 package), to
connect MiRICi-E3T3 to the coaxial E3 or T3 lines.
Note
Note