Specifications

Installation and Operation Manual Chapter 2 Installation and Setup
MiRICi-E3T3 Ver. 2.2 Disconnecting MiRICi-E3T3 2-3
2.6 Connecting MiRICi-E3T3 to the SFP-CA Module
For first use, you have to assign an IP address to MiRICi-E3T3 and specify a mode
of operation. To do so, you can use RAD’s SFP-CA module illustrated in
Figure 2-2 . You can also use this module to upgrade MiRICi-E3T3’s software.
When you connect SFP-CA to a specific PC for the first time, you have to install
the SFP-CA driver on that PC, and configure the PC network parameters for
communication with SFP-CA. Refer to
Chapter 3 for details.
All SFP-CA modules have the same MAC address (00-00-E8-00-00-01).
³ To connect MiRICi-E3T3 to the SFP-CA unit:
1. Choose the desired operation mode using the DIP switches on MiRICi-E3T3’s
underside as explained in
Required Equipment
2. MiRICi-E3T3 requires no special tools for installation.
3. Setting the Switches.
4. Connect the DC adapter to the SFP-CA configuration module and use the
power cord to connect the DC adapter to the mains.
5. Plug the USB connector of SFP-CA into a free USB port of a PC.
6. Plug MiRICi-E3T3 into the SFP socket on the opposite side on the SFP-CA unit.
To a USB Port on a PC
MiRICi-E3T3
To the DC
Adapter
Figure 2-2. SFP-CA Configuration Module
2.7 Disconnecting MiRICi-E3T3
Before physically disconnecting MiRICi-E3T3, you have to first release the device
using the Safely Remove Hardware utility.
³ To release MiRICi-E3T3:
1. Close all relevant management applications.
2. In the taskbar, double-click the Safely Remove Hardware icon.
Note