Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-2 Setting the Switches MiRICi-E3T3 Ver. 2.2
2.4 Required Equipment
MiRICi-E3T3 requires no special tools for installation.
2.5 Setting the Switches
MiRICi-E3T3 includes a 2-section DIP switch used to select one of the following
working modes of the device:
• Database initialization
• Normal operation
• Software download
• Configuration.
³ To select the working mode:
• On MiRICi-E3T3’s underside, set the DIP switches as listed in
Table 2-1 to
enable the desired working mode.
SW1
SW2
OFF
ON
SW2 SW1 State
OFF OFF INIT DB
OFF ON Normal
ON OFF SW Dwnld
ON ON Config
Figure 2-1. DIP Switch Location
Table
2-1. DIP Switch Settings
Switch Position
Function
SW2 SW1
OFF OFF Database initialization
OFF ON Normal operation (factory setting)
ON OFF Software download
ON ON Configuration