Specifications

MiRICi-E3T3 Ver. 2.2 Package Contents 2-1
Chapter 2
Installation and Setup
2.1 Introduction
Housed in a Small Form Factor Pluggable (SFP) package, MiRICi-E3 and MiRICi-T3
comply with the Multi-Source Agreement (MSA) and can be inserted into any
MSA-compatible host unit.
MiRICi-E3T3 is an autonomous plug-and-play hot-insertion module. You can
configure a MiRICi unit while it is plugged into the host device or by using RAD’s
SFP-CA configuration module illustrated in
Figure 2-2 .
MiRICi-E3T3 is equipped with DIP switches on its underside that enable setting
the MiRICi unit to various operation modes. Operation modes depend on the
desired task and are listed in
Table 2-1 together with the associated DIP switch
settings.
In addition, MiRICi-E3T3 can be managed via an I
2
C Interface (out-of-band) and/or
a Web-based management interface. For additional information, refer to
Chapter 4 .
2.2 Site Requirements and Prerequisites
MiRICi-E3T3 is intended for installation in a free SFP (MSA-compatible) socket of
the host equipment.
The ambient operating temperature should be –40°C to 65°C (–40°F to 149°F),
at a relative humidity of up to 90%, non-condensing.
2.3 Package Contents
The MiRICi-E3T3 package includes the following items:
• Up to four MiRICi-E3T3 units
• Two adapter cables CBL-1023-BNC.
• SFP-CA configuration adapter module (if ordered).