Specifications

Quick Start Guide Configuring MiRICi-E3T3
2 Configuring MiRICi-E3T3 for First Use MiRICi-E3T3 Ver. 2.2
SW1
SW2
OFF
ON
SW2 SW1 State
OFF OFF INIT DB
OFF ON Normal
ON OFF SW Dwnld
ON ON Config
Figure 1. DIP Switches on MiRICi-E3T3’s Underside
3. Connect the DC adapter to the SFP-CA configuration module and use the
power cord to connect the DC adapter to the mains.
4. Connect the SFP-CA configuration module to a free USB port on your PC and
then carefully plug MiRICi-E3T3 into the socket on the opposite side of
SFP-CA.
To a USB Port on a PC
MiRICi-E3T3
To the DC
Adapter
Figure 2. SFP-CA Configuration Module
³ To configure the PC network parameters for the SFP-CA connection to
MiRICi-E3T3:
1. From the Windows Start menu, navigate to the Control Panel, and open
Network Connections.
A new local area network connection appears in the list of network
connections. If you switch to the Details view, the device name ADMTEK
ADM8511 USB TO FAST ETHERNET CONVERTER appears.
2. Right-click this network connection, and select Properties.
The Local Area Connection Properties dialog box appears with the General
tab open.
3. To the upper right, click Configure and then select the Advanced tab.
The Network Connection Properties dialog box appears, containing
properties associated with the USB configuration adapter.
4. Under Property, select Select Media. Under Value, select Home LAN, and then
click OK.
The dialog box closes and your settings are applied.
5. Open the Properties window again as explained above and double-click
Internet Protocol (TCP/IP).
The Internet Protocol (TCP/IP) dialog box appears.
6. To enable entering TCP/IP settings, select Use the following IP Address.
The IP Address, the Subnet Mask, and the Default Gateway field become
available.