Specifications

MiRICi-E3T3 Ver. 2.2 Configuring MiRICi-E3T3 for First Use 1
Quick Start Guide
This quick start guide instructs you on getting started with MiRICi-E3T3 and
upgrading software when necessary. It is divided into the following sections:
• Configuring MiRICi-E3T3 for first use
• Connecting MiRICi-E3T3 to a host device
• Replacing MiRICi-E3T3’s software.
1. Configuring MiRICi-E3T3 for First Use
Before you can start using MiRICi-E3T3, you have to assign an IP address to the
device and specify a mode of operation. To do so, connect MiRICi-E3T3 to a PC
via RAD’s SFP-CA adaptor as illustrated in
Figure 2 .
When you connect SFP-CA to a specific PC for the first time, you have to install
the SFP-CA driver on that PC, and configure the PC network parameters for
communication with SFP-CA. The driver installation requires a PC that has the
Windows XP operating system with Service Pack 2.
³ To install the SFP-CA driver on a PC:
1. Insert the Technical Documentation CD into the CD drive of the PC.
The CD main menu appears.
2. Click the link to the MiRIC/MiRICi Family product page.
The MiRIC/MiRICi Family product page appears, with an entry for the
SFP-CA documentation and driver.
3. Click the SFP-CA driver link.
The SFP-CA driver is installed in the background. No further action is
required to install the driver.
³ To connect MiRICi-E3T3 to a PC:
1. Ensure that you have installed the SFP-CA driver on the PC as explained
above.
2. Enable Configuration mode for MiRICi-E3T3 by setting both DIP switches on
the device’s underside to ON.