Specifications

Chapter 3 Configuration Installation and Operation Manual
3-6 HS-RN MP-2100/2104 Ver. 12.6, MP-4100 Ver. 2.0
Parameter Function Values
Map Type Selects the timeslot mapping method
when the destination is a TDM main
link or CL port.
For a module installed in a MP-4100
chassis, this field appears only for the
UNI-BRD RX mode.
• When using the BI-DIR or UNI-BRD TX mode for a
module installed in a MP-2100/2104 chassis, this
field automatically changes to N/A, to remind you
that the destination must be selected using the
DEF TS command
• When using the UNI-BRD RX or BID-BRD RX
mode, you can select the desired mode:
USER You can select the desired uplink
timeslots on the timeslot map.
SEQUENCE The external port is assigned
consecutive timeslots, starting with
the timeslot specified by means of
the Start TS parameter.
Default: N/A
Start TS Selects the starting timeslot in the
frame of the destination TDM uplink
port.
This parameter can be selected only
when using the SEQUENCE mapping
mode; when using any other mode,
this field automatically changes to
N/A.
For a module installed in a MP-4100
chassis, this field appears only for the
UNI-BRD RX mode.
The allowed range is 1 to 31 for E1 ports, and 1 to 24
for T1 ports.
Default: N/A
3.5 Assigning Timeslots
After performing the configuration of the individual module channels, it is
necessary to assign the uplink bandwidth to each connected channel.
• When using the BI-DIR or UNI-BRD TX mode in the module installed in the
MP-2100/2104 chassis, use the DEF TS command to assign a timeslot or
DEF SPLIT TS A:B:C command to assign a fraction of a timeslot as explained in
the
Megaplex-2100/2104 Installation and Operation Manual . For the module
installed in the MP-4100 chassis, use the Configuration>System>TS
Assignment screen.
• When using the UNI-BRD RX or BID-BRD RX mode in the module installed in
the MP-2100/2104 chassis, timeslot assignment for the receive direction is
made using the dedicated routing fields of the DEF CH command. For the
module installed in the MP-4100 chassis, use the Configuration>
Physical Layer>IO screen.
When using any broadcast mode or latency-optimized mode, split timeslot
assignment cannot be used. In this case you must assign a full timeslot to each
HS-RN channel operating in this mode.
Note