Specifications
Installation and Operation Manual Chapter 3 Configuration
HS-RN MP-2100/2104 Ver. 12.6, MP-4100 Ver. 2.0 3-3
Table
3-1. Channel Parameters
Parameter Function Values
Connect
(MP-2100/2104
only)
Determines whether the channel is
connected to the internal TDM buses
of the Megaplex chassis
NO The channel is disconnected. You can still
program the desired parameters, so the
channel will be ready to operate when
needed.
YES The channel is connected to a legacy main
link port, and can carry traffic.
Default: NO
Admin Status
(MP-4100 only)
Used to enable/disable the flow of
traffic through the selected port
UP The flow of traffic is enabled.
DOWN The flow of traffic is disabled. This state
should be selected as long as the port
configuration has not yet been completed,
or when it is necessary to stop traffic flow
through the port.
Default: DOWN
Bus Connection
(MP-2104/2100
only)
Selects the number of TDM buses
that can be used by the module.
This parameter is relevant only in
Megaplex units with CL.2 modules
running software version 11.0 or
higher; otherwise, only two TDM
buses (buses A or B) can be used, and
all the HS-RN channels are routed to
the same bus.
The selection made for one channel is
automatically applied to all the
channels (the last selection overrides
all prior selections).
The selected number cannot exceed
the number of the TDM buses
selected by means of the SET USER
command
FULL All the four TDM buses can be used.
PARTIAL The module can use only two buses
(either bus A or B), even if the number of
TDM buses selected by means of the SET
USER command is greater.
Default: PARTIAL
Encapsulation
Mode
Controls the encapsulation mode
according to the user application in
the HDLC model.
The V.110 model operates in
Bandwidth Optimized mode only,
but the end-to-end data latency is
at minimum.
Bandwidth Optimized – enables uplink bandwidth
optimization (using split timeslots) in applications
less sensitive to latency.
Latency Optimized – enables minimum end-to-end
data latency. In this mode split timeslots are not
available and the uplink bandwidth should be
always transferred over full 64 kbps timeslots.
Default: Bandwidth Optimized
Format Specifies the channel operating
mode
ASYNC Asynchronous mode
SYNC Synchronous mode
Default: ASYNC (MP-2100), SYNC (MP-4100)