Specifications

Chapter 3 Configuration Installation and Operation Manual

3-2 HS-RN MP-2100/2104 Ver. 12.6, MP-4100 Ver. 2.0

where SS is the slot number, and CC is the channel number (1 to 4). For the

parameter description, see

Table

3-1.

HS-RN modules are identified as HS-R by the Megaplex-2100/2104 management

system, including the supervisory terminal.

3. Configure the rate of each module port by assigning timeslots as described in

Section

3.5

Make sure to plan ahead the configuration sequence, because

Megaplex-2100/2104 databases can be updated only after correctly completing

the configuration activities: any sanity error will prevent saving the changes to

the database being modified.

3.3 Configuration Sequence for the MP-4100

Chassis

³ To configure an HS-RN module and put it into service:

1. Add an HS-RN module not yet installed in the Megaplex-4100 chassis to the

database. This allows preconfiguring the module parameters, so that the

module will immediately start operating in the desired mode as soon as it is

installed in the enclosure.

For the supervision terminal, use the Configuration>System>Card Type

screen.

2. Configure the CL or M8E1/M8T1 module port parameters (depending on the

HS-RN module application). For the configuration procedure, refer to the

appropriate Installation and Operation Manual.

3. Configure the HS-RN port parameters. For the supervision terminal, use the

Configuration>Physical Layer>I/O screen.

4. Configure the timeslot assignment of each module port, using the

Configuration>System>TS Assignment screen.

Make sure to plan ahead the configuration sequence, because Megaplex-4100

databases can be updated only after correctly completing the configuration

activities: any sanity error will prevent saving the changes to the database being

modified.

3.4 Configuration Parameters

Each HS-RN channel (external port) can be independently configured in

accordance with the system requirements.

Table

3-1

explains the programmable parameters of the HS-RN channels, and

their ranges of values.

Note