Specifications

Configuration Parameters A-1
Appendix A
Operation with FCD-E1M
and FCD-T1M
Operation of the HS-R module with FCD-E1M and FCD-T1M is generally similar to
its operation with the Megaplex-2100/2104 family of modular E1/T1 multiplexers,
as previously explained in this manual. The differences are seen in the following
two areas:
• Configuration parameters
• Alarm messages
This appendix identifies and lists these differences only. For a full description of the
configuration parameters and alarm messages, refer to the Configuration
Instructions and Alarm Messages sections in this manual.
A.1 Configuration Parameters
Table A-1 indicates the difference in the channel parameters when operating with
FCD-E1M and FCD-T1M.
Table A-1. FCD Channel Parameters
Parameter FCD Difference
CONNECT No change
DESTINATION Not applicable
SIGNAL FORMAT No change
RATE No change
DATA (LENGTH) No change
PARITY BIT No change
STOP BIT No change
CTS No change
CLOCK MODE No change
TDM LINK Not applicable
DCD & DSR No change
PRIORITY Not applicable
LINK TO Not applicable
OPERATION MODE Not applicable