Specifications

Module Installation and Operation MP-2100 HS-R Installation and Operation Manual
2-4 Normal Indications
Cable Connections
Identify the cables intended for connection to each port of this module, and
connect them into the appropriate connectors.
Two channel splitter cables are available from RAD. These enable direct
connection of data equipment with RS-232 interfaces to an HS-R channel
connector:
• CBL-HSR/F, which terminates into two 25-pin D-type female connectors.
• CBL-HSR/M, which terminates into two 25-pin D-type male connectors.
The wiring diagram of the two cables is shown in Figure 2-2.
2
3
4
5
6
8
15
17
20
24
7
2
3
4
5
6
8
15
17
20
24
7
2
3
4
5
6
8
15
17
20
24
7
14
16
19
13
21
12
11
18
25
23
TD1
RTS1
CTS1
DSR1
DCD1
XCLK1
RCLK1
DTR1
XCLK-EXT1
GND
RD1
Channel 1
Channel 2
To HS-R Port
Connector
TD2
RTS2
CTS2
DSR2
DCD2
XCLK2
RCLK2
DTR2
XCLK-EXT2
RD2
Module
Side
User's Equipment
Side
.
.
.
.
.
Figure 2-2 Channel Splitter Cable Wiring
2.4 Normal Indications
During normal operation, the LOS indicators of all the connected channels must
be off.
The TEST indicators must be off, except when the corresponding channel is
engaged in a test. During tests, the channel does not carry user's traffic.