System information

Chapter 2
Agent Configuration Mode
This section explains the Megaplex management operations that are performed in
RADview’s Agent mode.
2.1 System Level Agent Operations
In the Agent mode, you can display configuration information for the current
Megaplex configuration in the Megaplex, Card and Port Levels. Data accessed in
the Agent mode may be used for comparison and analysis when adjusting
parameters in the Edit Configuration view.
You can display active alarms and history log for the Megaplex, cards and ports. In
addition, you can view and analyze port statistics at the management station from
the Agent mode.
Any of the slot positions can be selected. Only correctly installed slot positions can
be monitored and zoomed. The Megaplex view displays the rear panel of each of
its installed cards, along with the card's name. If a slot is empty, no rear panel is
displayed. If an unknown card is installed, the rear panel displays "?" (unknown).
If a slot in the agent is incorrectly installed, a red frame surrounds it. If a slot is
selected, a light blue frame surrounds it.
System Level Agent Operations 2-1