System information

Chapter 1 Edit Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
1-32 System Level Configuration Operations
Parameter Possible Values / Remarks
Ext D-Ch TS TS on the non-V5.1 ML on which the External D channel TS is defined (and is
transferred via Bypass between the V5.1 ML and the non-V5.1 ML)
1..31
D-Ch Compression Indicates if this ISDN D channel TS is Compressed or not
No, Yes
D-Ch Rate (bits) Rate of the ISDN D channel
2, 4, 8
D Ch Start Bit Start Bit of the ISDN D channel on the TS of the non-V5.1 ML on which it is
defined
1, 3, 5, 7
Saving V5.1 Variants
Saving V5.1 Variants causes the system to perform a Sanity Check. To ensure that
you will successfully save the V5.1 Variants, perform an update of the system before
saving the V5.1 variants. V5.1 Variants will be saved only if the update operation
succeeds without errors (see Updating the Configuration to the Agent) and the
configuration complies with the V5.1 variant configuration

To save a V5.1 variant:
1. Select the desired variant in the V5.1 Variants Dialog Box (Figure 1-26) click
<Save Variant>.
A confirmation message appears.
Figure 1-33. Save V5.1 Variants
2. Click <OK> to confirm save.
Reading V5.1 Variants
The Read operation enters the selected Variant data in the NMS database, for the
selected link.

To enter V5.1 Variant data in the NMS database:
1. Select the desired variant in the V5.1 Variants Dialog Box (Figure 1-26) click
<Read Variant/s…>.
The Read Variants dialog box appears listing all existing programmed
variants for this link in the agent configuration.
2. Select all variants by clicking the All Variants checkbox or select an individual
variant.
Note