System information

Chapter 2 Agent Configuration Mode RADview-PC/TDM Megaplex-2100/2104 User’s Manual
2. Click <Apply>.
Defining Scope of Alarm Reports
Using the Reports command, you can define the scope, type and severity of alarm
reports that you will receive at the network management station.

To define an alarm report:
1. In the Fault menu, click Alarms, followed by Configuration and Reports…
The Alarm Report dialog box appears.
2. Set the desired severity level for each report: Event, Warning, Minor, Major,
or Critical.
3. Click <Set>.
Figure 2-33. Alarm Report Dialog Box
Table 2-18. Alarm Report Parameters
Parameter Possible Values / Remarks
Trap Define whether you want to receive traps for all alarms or for only those alarms of at
least a certain severity.
Alarm On Severity - Minimum level of severity required for sending a trap to the
network management station. Trap severity must be equal or higher than buffer severity.
Alarm Off Severity - Maximum level of severity allowed for a trap not to be sent to the
network management station.
2-36 Megaplex Level Fault Operations