Specifications

Module Installation and Operation
2-10 MP2100M-LS-2 Modules - Installation and Operation Manual
2.6 Configuration Instructions
General
This section provides information on the configuration parameters of the LS-2
modules. The configuration activities required to select the desired values of
these parameters are performed by means of the management system used to
control the MEGAPLEX unit. The instructions appearing in this section assume
you are familiar with the management system being used: a supervision terminal
(covered by Chapter 3 of the MEGAPLEX-2100 Installation and Operation
Manual), or a network management system, e.g., the RADview network
management system (refer to the RADview User's Manual for instructions).
The modules have two types of parameters:
• Internal port parameters.
• External port parameters.
Internal Port (Module) Parameters
Table 2-3 explains the internal port parameters, and their range of values.
Table 2-3. Internal Port Parameters
Parameter Description
Connect Determines whether the module will be connected to the main link.
YES Module is connected
NO Module is disconnected. You can still program the desired parameters, so the
module will be ready to operate when needed
Group The number of the module group. Enter a number in the range of 1 through 12 that is
unique to this group. Refer to Section 1.2 for details
Member Id The number of the module as a member of its group. Enter a number in the range of 1
through 4 that is unique in this group. Refer to Section 1.2 for details
Envelope Assignment Selects the method used to assign envelopes to the individual channels, automatic or
manual
Link to Selects the main link to which the module will be connected. The main link is specified by
indicating the number of the I/O slot in which the desired main link module is installed.
The same link must be selected for all the modules of a given group
External Port (Channel) Parameters
Table 2-4 explains the programmable external port parameters, and their range
of values.