Specifications

Module Installation and Operation
2-6 MP2100M-LS-2 Modules - Installation and Operation Manual
2.3 Module Installation
For your safety, do not connect cables to the module before the module is
installed in a properly installed and grounded MEGAPLEX enclosure.
Installation in
Enclosure
Refer to the system installation plan and insert the module in the assigned I/O
slot of the MEGAPLEX enclosure.
For MTLS-2 and MTLS-2/2TS modules, install the required interface module
in the corresponding slot:
• IM-S68/2 interface module for the MEGAPLEX-2100F.
• IMB-S68/2 interface module for the MEGAPLEX-2100B.
Cable Connections
Identify the cables intended for connection to the module, and connect the
cables to the appropriate connectors.
Modules LS-2, LS-2A, LS-2A/2TS
• If the module channels connect to a main distribution frame, connect
appropriate cables to the 44-pin module connector. Refer to Appendix A for
connector pin assignments.
• If the channels connect directly to equipment, connect an octopus cable to
each 44-pin module connector. Connect each 25-pin connector, in
accordance with the marking near the cable end, to the user's equipment.
 If the user equipment connected to a channel has a DTE interface,
connect the user equipment via a standard straight cable to the
corresponding connector of the octopus cable.
 If the user equipment connected to a channel has a DCE interface, a
short (30 cm, 1 foot) cross cable must be connected at the
corresponding user-end connector of the octopus cable. Connect the
user equipment via a standard straight cable to the corresponding
connector of the cross cable.
Modules MTLS-2, MTLS-2/2TS
• If the module channels connect to a main distribution frame, connect
appropriate cables to the 68-pin connectors of the corresponding interface
module. Refer to Appendix A for connector pin assignments.
• If the channels connect directly to equipment, connect an CBL-LS202
octopus cable to each connector. Connect each 25-pin connector, in
accordance with the marking near the cable end, to the user's equipment.
Module LS-2/M
Connect the line cables to the corresponding RJ-11 connector.