User`s manual

Chapter 4 Configuring a Flow-Based Point-To-Point Application Installation and Operation Manual
4-6 Configuring the System Parameters RV-EMS/NGN LA-210 Ver. 1.5
3. Press <F> to navigate to User Port 2 and configure the respective parameters
as illustrated below.
Bridge Port 333 on User Port 2 enables the management PC to access
LA-210.
ETX-202
Configuration>Bridge>Bridge Port
Port Label > (4)
Bridge port > (User 2)
1. Port\Stacking VID[1 - 4094] ... (333)
2. Default Priority Tag [0 - 7] ... (7)
3. Tag Handling (Stack)
Please select item <1 to 3>
F-Forward
ESC-prev.menu; !-main menu; &- exit 1 M/ 1 C
Figure 4-5. ETX-202 Server User Port 2– Bridge Port Menu
³ To log off:
• If not already done, press <S> to save your new settings and, then press <&>
to terminate the connection.
Configuring ETX-202 Client
This section instructs you on configuring ETX-202 Client.
³ To configure the VLAN settings:
1. Navigate to the Encapsulation menu
(Configuration>System>Management>Host>Encapsulation).
ETX-202
Configuration>System>Management>Host>Encapsulation
1. Host Tagging (Tagged)
2. Host VLAN ID[1 - 4094] ... (555)
3. Host VLAN Priority[0 - 7] ... (7)
4. Security Definition > (All)
>
Please select item <1 to 4>
ESC-prev.menu; !-main menu; &-exit 1 M/ 1 C
Figure 4-6. ETX-202 Client – Enabling Host Tagging
2. Select Host Tagging.
Host tagging is enabled and additional parameters become available.
3. Select Host VLAN and enter 555.