User`s manual

Chapter 1 Introduction User’s Manual
1-2 RV-EMS/NGN LA-210 Overview RV-EMS/NGN LA-210
1.2 RV-EMS/NGN LA-210 Overview
This chapter explains the steps required to get the RADview-EMS/NGN LA-210
management system for LA-210 version 1.5 up and running. It describes the
graphical user interface, configurations, security and fault management. Specific
tasks possible with RADview-EMS/NGN LA-210 are dealt with in the subsequent
chapters in this manual. All the configurations and management support in this
manual are tasks that can be performed with RADview.
The RADview-EMS/NGN management system for LA-210 provides you with all the
tools necessary to monitor the performance and configure the device parameters
for its local and remote devices.
The RADview-EMS/NGN management system for LA-210 units is accessed in two
levels:
• System Level
• Port Level:
 SHDSL
 10/100BASE-T
Overview of the RADview FCAPS Model
RADview provides a complete management solution for monitoring and
controlling the RV-EMS/NGN LA-210 system. The RADview solutions conform to
ITU-T Telecommunication Management Network (TMN) recommendations for
SNMP management systems, known as the FCAPS model:
• Fault management – detects and correlates fault in network devices, isolates
faults, and initiates recovery actions.
• Configuration management – tracks configuration changes, and configures,
installs, and distributes software and configuration files across the network.
• Accounting management – collects accounting data and generates network
usage reports.
• Performance management – continuously monitors network performance
(QoS, CoS) and resource allocation.
• Security management – controls and restricts access to network resources.