User`s manual

Chapter 3 Configuration Management User’s Manual
3-32 Setting the Operational Parameters RV-EMS/NGN LA-210
Parameter Possible Values / Remarks
OAM Mode
Determines the OAM behavior.
Disabled: No CC performed
Initiate: The unit will initiate and respond to OAM messages
React: The unit will respond to OAM messages, but not initiate them.
Default: Disabled
Continuity Verification
Mode
Determines the CC behavior. LB Based is used only for RAD proprietary.
LB Based
CC Based
Default: Disabled
Note: This parameter is available in Initiate/React OAM mode .
OAM Destination
Address Type
Unicast
Multicast
Default: Unicast
Note: This parameter is available in Initiate OAM mode .
OAM Destination MAC
Address
Determines the MAC address sent in OAM messages, configurable only for
Unicast MAC Address.
Default: 01-20-d2-00-01-00 + MD Level in RAD Proprietary, Standard OAM MAC
Address + MD Level in Standard.
Default CC Priority The priority CFM messages will be sent if no service is defined on the flow. If a
service is defined, the CC will be performed at the highest priority service on the
flow.
Note: This parameter is available in Initiate OAM mode .
³ To edit a flow:
1. In the OAM List screen, select the desired flow and click <Change>.
The Change Flow dialog appears. The Change Flow dialog is identical with
the Add Flow dialog (
Figure 3-23 ).
2. Configure the parameters as outlined in
Table 3-13 .
3. Click <Set>.
The flow has been modified.
³ To edit a service:
1. Before you can edit a service, set the OAM mode to React or Initiate,
otherwise the service parameters will be read only.
2. Select the desired service.
The associated service parameters appear.