User`s manual

Chapter 3 Configuration Management User’s Manual
3-22 Setting the Operational Parameters RV-EMS/NGN LA-210
³ To edit an Internal Queue profile:
1. In the Internal Queue Profiles list, select the desired Internal Queue profile
and click Change.
The Change Internal Queue Profile screen appears.
2. Edit the parameters as detailed in
Table 3-10 and then click Set.
The Internal Queue Profile parameters are updated.
Figure 3-18. Internal Queue Profile Parameters Screen
Table
3-10. Internal Queue Profile Parameters
Parameter Possible Values / Remarks
ID Selects an Internal Queue profile identification number.
1–8
Scheduling Defines the queue scheduling method. Currently, if one of the internal queues is
configured to the WFQ mode, the queues with the higher priority cannot be
configured to the strict mode.
Strict – High-priority queues that are always serviced first. If a lower-priority
queue is being serviced and a packet enters a higher queue, that queue is
serviced immediately.
WFQ – Weighted Fair Queuing, if one port does not transmit, its unused
bandwidth is shared by the ‘transmitting’ queues according to the assigned
weight.
Default: Strict
Note: In configurations with Strict and WFQ queues, the WFQ frames are
transmitted only after the transmission of frames associated with the Strict
queues is completed.
Weight Determines the weight of an internal queue when the scheduling weight is
configured to WFQ
3–110
Default: 3