User`s manual

Chapter 3 Configuration Management User’s Manual
3-20 Setting the Operational Parameters RV-EMS/NGN LA-210
Figure 3-16. Adding Marking Profile
2. Configure the parameters as detailed in Table 3-9 and then click Set.
The Marking profile is added.
Table 3-9. Marking Profile Parameters
Parameter Possible Values / Remarks
ID Selects a Marking profile identification number.
1–8
Name Assigns a nam to the ingress bandwidth profile.
String of up to 20 characters
Default: MarkingProfile<ID>
Marking Method Defines the Committed Information Rate (CIR) for the current profile. The CIR
specifies a bandwidth with committed service guarantee (“green bucket” rate).
802.1p
DSCP
IP Precedence
Default: 0
³ To map Marking profiles to user priorities:
1. In the map, select the desired Marking values that are associated with user
priorities.
 To select multiple Marking Map values, press and hold <Ctrl> and click the
desired Marking Mapping values.
2. To modify the Marking map values, click Marking Mapping and then select a
value between 0 (lowest priority) and 7 (highest priority).
3. Click Set.
The new Marking Mapping values are set.