User`s manual

Chapter 3 Configuration Management User’s Manual
3-14 Setting the Operational Parameters RV-EMS/NGN LA-210
Parameter Possible Values / Remarks
Egress Rate Limit (Kbps)
Defines the rate limit for all queues together.
64 – 100000
Default: 100000
VLAN Tag Ether Type
(hex)
Defines the VLAN Tag identifier.
0 – FFFF
Default: 8100
Configuring the Flows
In Flow mode, incoming customer traffic can be mapped to Ethernet flows
according to user defined per-port criteria.
This section explains how to select the flow interfaces and specify the flows
according to specific criteria.
³ To verify that LA-210 operates in Flow mode:
1. In the LA-210 View window, select the System view.
2. On the menu bar, click Configuration > System Parameters.
The System Parameters dialog appears displaying the current mode.
Configuring the Quality of Service
RV-EMS/NGN LA-210 supports Quality of Service (QoS) in DSL egress direction.
Traffic is classified according to VLAN priority (802.1p), DSCP (bits 0-5 in IP TOS
byte) and port based. Mapping classification results into four transmit priority
queues with strict priority. Before you can start configuring flows, you have to
configure the QoS parameters.
Configuring Ingress BW Profiles
The section below explains how to view, add, edit and remove Ingress bandwidth
(BW) profiles.
³ To view existing Ingress BW Profiles:
1. In the LA-210 View window, select the System view.
2. On the menu bar, click Configuration > QoS.
The QoS menu appears.
3. Select Ingress BW Profiles.
The Ingress BW Profiles list appears.