User`s manual

Chapter 3 Configuration Management User’s Manual
3-12 Setting the Operational Parameters RV-EMS/NGN LA-210
The SHDSL Layers Parameters window appears with an overview of SHDSL
parameters set.
Figure 3-8. SHDSL Layers
³ To configure SHDSL line parameters:
1. In the SHDSL Layers screen, click Edit and then select Line…
The Edit SHDSL screen appears.
2. Configure the parameters as needed and then click Set.
Figure 3-9. SHDSL Lines Screen
Table
3-5. SHDSL Lines
Parameter Possible Values / Remarks
TC Layer Operational mode
46–65 Octets
ATM
Default: 46–65 Octets
Note: Only the first line can be configured to ATM. The remaining lines remain
invisible.
Wires Wire operation mode for SHDSL lines
2 Wire
4 Wire
6 Wire
8 Wire
Default: 2 Wire
Note: Configurable only if TC Layer is set to ATM